Inhaltsverzeichnis
Werbung
Intended Use
The machine is intended for tacking of cardboard, insulating material,
fabric, foils, leather and similar materials on surfaces of wood or materials
similar to wood. The machine is not suitable for the attachment of wall and
ceiling panelling.
The intended use also includes an operation following the operating
instructions.
Any use beyond these parameters (different media, applying force) or any
changes (reconstruction, no original accessory) can lead to serious risks
and is regarded as use that is contrary to the intended purpose. The opera-
tor is liable for any damage caused by improper use.
Before first Use
Remove the unit and the accessory out of the packaging. Keep packaging
materials out of reach of children. There is risk of suffocation!
Inserting Staples
This stapler can drive staples 8 – 16 mm long and 11.3 mm wide and T-Nails
15 – 16 mm long.
Please keep in mind that staples and nails must be suited to the material they
are used in. The harder the material is, the shorter the staples or nails should
be.
1. Unplug the unit before inserting staples.
2. Turn the unit upside down.
3. Press the lever (6) in direction of the magazine
slider (7) and pull out the magazine slider.
4. Insert a strip of staples (max. 100 staples) with
the clip facing down into the magazine (see
image a).
5. Push in the magazine slider as far as it will go
until the lever (6) audibly snaps in.
Operation
9
Werbung
Inhaltsverzeichnis
