Intended Use; Before First Use; Installing/Exchanging Tools; Setting The Torque - Westfalia 94 60 30 Originalanleitung

Intended Use

▪ The impact wrench with an appropriate tool has been exclusively designed for
loosening and tightening of screws, bolts and nuts, etc. in the workshop, in
agricultural vehicles, equipment and machinery.
▪ The intended use also includes an operation following the operating instruc-
tions. Any use beyond these parameters (different media, applying force) or
any changes (reconstruction, no original accessory) can lead to serious risks
and is regarded as use that is contrary to the intended purpose.

Before first Use

Unpack the impact wrench and the accessory and check all parts for any damage
in transit. Dispose of packaging materials or store them out of reach of children.
Plastic bags etc. may become a deadly toy for children.

Installing/Exchanging Tools

▪ The impact wrench features a ½"' square drive (1). That means you can
operate it with tools that have a ½" shaft.
▪ Please note! Before changing the socket/the tool, unplug the impact wrench
from power mains to avoid unintentional start-up.
▪ Firmly push the desired socket/tool onto the square drive, so that it cannot
loosen when working.

Setting the Torque

With the buttons (4) and (5) you can set the torque in steps of 10 Nm for clock-
wise rotation. The selected torque is shown in the display (6).

Operation

1. Put the impact socket (7) to be used onto the square drive (1) of the impact
wrench. Always use the correct size of socket in order to ensure the right
fastening torque
2. Connect impact wrench with a wall socket and press the toggle switch (2) to
operate the impact wrench. While working, hold the unit firmly with your hands.
The unit is designed for forward and reverse rotation. Press the toggle switch,
on the top part, marked with R (REVERSE) and the motor will run counter
clockwise in order to loosen bolts and nuts.
Press the toggle switch on the bottom part, marked with F (FORWARD) and
the motor will run clockwise for tightening bolts and nuts.
Operation
10