IndoorCycling Group Myride Benutzerhandbuch Seite 6

1: REMOvE THE WAvE STAND fROM THE PACkAGING
The wave stand is very heavy! It requires at least two people to remove the stand
from the packaging. Make sure you have a firm grip, and avoid holding the edges
(which may bend). Please verify when unpacking that all of the required parts are
included with the stand.
2.
2: ATTACH THE SIDE fINS
Place the wave stand on its side. Secure the two small fins to the rear of the wave
stand, rubber foot side down, by bolting into the posts.
When wall mounted, the Myride system does not use the base plate or the center fin.
Version 2.0 Copyright by Indoorcycling Group GmbH 2012 | www.indoorcycling.com
4xA / 4xC / 8MM kEY
3: PREPARE THE WALL ANCHORS
Measure up 55" (1400 mm) from the floor. Insert two wall anchors 10.5" (265 mm) apart,
following the anchor manufacturer's directions. Note: the anchor must be rated to support at
least 100 lbs. Be sure the wall itself can support the weight of the stand!
3.
IMPORTANT! The weight of the Myride system of 92.5 lbs requires
the use of proper wall mounting fixtures supporting the weight
of the system. If you are unsure what fixtures are suitable, please
consult your local professional. Warranty may void in case of
inproper mounting.
265 MM
4: MOUNT THE MYRIDE TO THE WALL ANCHORS
With at least two people, lift the Myride system onto the wall anchors.
ATTENTION! the left and right support are
required to keep the required clearance to
the wall and avoid buckling of the cables
reaching out of the terminal