IndoorCycling Group Myride Benutzerhandbuch Seite 11

(OPTIONAL)
4: PERfORM A CHANNELSCAN
In order for the Myride system to list and allow to change TV channels successfully, it must scan
the incoming television signal. This process might take a while.
Once you have chosen the signal type, a 'scan' button will appear next to its checkbox. Touch
the scan button to start a channelscan. (This process can take up to thirty minutes.) During this
time, the Myride is detecting available channels and adding them to the TV menu. While scan-
ning, the Myride will display a series of technical messages. When it is finished, the message
'channelscan finished' will appear at the end of the list. You can now navigate away from the
message by touching the 'cancel' button (the results have already been saved).
Version 2.0 Copyright by Indoorcycling Group GmbH 2012 | www.indoorcycling.com
(OPTIONAL)
5: EDITING THE CHANNEL LIST
Once the channel scan has finished, you can edit the list. Choose 'TV Channel Editor' in the left
pane to bring up the channel editor. If the channelscan was successful, a list of detected chan-
nels will appear in the next pane over (picture below). By selecting each channel in that pane,
you can choose to activate or inactivate individual channels.
If the channel list is empty, please verify that you selected and scanned the correct signal type.
Most clubs' in-house television systems are analog (NTSC or PAL), while cable or over-air televi-
sion is typically digital (ATSC or DVB). If you are unsure, contact your television provider or try
scanning different television signal types.
Note: some cable or satellite television stations may be encrypted (for example, premium
digital cable signals). They will be detected by the channelscan, but will appear as static
and should be removed from the channel list in the channel editor.