IndoorCycling Group Myride Benutzerhandbuch Seite 4

2. INSTALLATION.
THE MYRIDE SYSTEM
The Myride system is a touchscreen media console for use as an exercise aid. The system
consists of an industrial computer and touchscreen, housed in a sheet metal wave stand. The
computer and touchscreen are fully connected and configured at the factory, but the wave
stand requires some assembly on-site. Depending on mounting and other options, setup may
take from 30 minutes to slightly over one hour.
SETUP REQUIREMENTS
Tools and parts: All tools and parts necessary for assembling the wave stand are included in
the original shipping box. Wall mounting the Myride system will require additional hardware
and tools.
CUSTOMER SUPPORT
For the most up-to-date customer support, please visit the website at www.indoorcycling.com.
Basic maintenance and support questions are addressed in this manual. If your problem is not
answered by these resources, or if your Myride system requires service, please contact
your distributor.
INSTALLATION NOTES:
Myride® is a product for professional and / or commercial use. Such training equipment is
intended for use in training areas of organizations such as fitness clubs or sport associations
where access and control is regulated and the legal responsibility for use lies with such club
or association.
fOOT PRINT Of MYRIDE SYSTEM:
WEIGHT Of MYRIDE SYSTEM:
HEIGHT Of MYRIDE SYSTEM:
fOOT PRINT Of MYRIDE + bIkE:
WEIGHT Of MYRIDE + bIkE:
Version 2.0 Copyright by Indoorcycling Group GmbH 2012 | www.indoorcycling.com
86 x 56 CM / 34 x 22 INCH
42kG / 92.5 LbS
150CM
APPROx. 200 x 65 CM / 79 x 26 INCH
APPROx.100 kG / 220 Lb
1.
3 WAvE STAND
ALLEN kEY
8.00 MM
ALLEN kEY
fOR bOLT A
4.00 MM
fOR bOLT b
2.
bASE PLATE
3.
Stabilizer rear Fin'S
A. b.
M10x16 M5x10
4x 6x
C. D.
6x M5x10
10.5 MM 5.5 MM
4x
6x
4 x 30mm
4 x M10x16
6 x 11mm