IndoorCycling Group Myride Benutzerhandbuch Seite 5

1: REMOvE THE WAvE STAND fROM THE PACkAGING
The Wave stand is very heavy! It requires at least two people to remove the stand from the
packaging. Make sure you have a firm grip, and avoid holding the edges (which may bend).
Please verify when unpacking that all of the required parts are included with the stand. Place
the wave stand on the side for easier assembly.
2.
2: ATTACH THE bOTTOM PLATE AND SIDE fINS
Place the Wave stand on its side for assembly (see illustration). Place the base plate on the
stand and secure the two small fins to the rear by bolting through the base plate and into the
screw posts at the bottom of the stand. Before tightening the bolts, tap or push the base plate
to ensure it is seated firmly against the bottom of the wave stand.
Version 2.0 Copyright by Indoorcycling Group GmbH 2012 | www.indoorcycling.com
4xA / 4xC / 8MM kEY
3: ATTACH CENTER fIN AND RUbbER fEET
Place the large center fin over the bolt holes in the wave stand and secure using six M5 bolts
with washers. Affix the four adhesive rubber pads to the base of the wave stand as shown in
the illustration.
3.
4: MOvE THE MYRIDE SYSTEM INTO POSITION
With at least two people, pick the Myride system up and move to its proper location. Use a
firm grip; do not slide or tilt the stand, as the weight of the unit may bend the metal frame. To
prevent the Myride system from tipping over, manufacturer recommends to bolt the unit to the
floor using the holes in the floor plate. Make sure sufficient bolts and anchors are being used.
RUbbER
PADS
6x b / 6x D / 5MM kEY
4x SELf ADHESIvE RUbbER PADS