Check You Have Received - Marlec Rutland 914i Windcharger Bedienungsanleitung

Rutland 914i Windcharger Installation & Operation
The fuse supplied must be fitted to protect the system.
The Rutland 914i Windcharger is suitable for sailing boats and some land
based applications. When storm winds are forecast the turbine can be re-
strained to minimise wear and tear particularly when installed on land based
applications where Furlmatic model windchargers are normally recommended.
Note that where the manufacturer recommends a furling type windcharger
should have been used the warranty is invalidated in cases of storm damage.
If in doubt, refer to your dealer, a competent electrical engineer or the
manufacturer.
Check You Have Received - See Rutland 914i Exploded View
24 x No.10x25mm special self-tapping screws for aerofoil blades
1 x No.4 x 13mm self tapping screw for tail bracket covers
2 x M6 x 16mm hex. Head screws for tail fin
2 x M6 nylock nuts for tail fin
1 x fuse and fuse holder
1 x main generator assembly
6 x aerofoil blades
1 x tail fin
2 x tail bracket covers
1 x nose cone + 3 x nylon fixing screws
1 x 6mm Allen key
1 x 2-way terminal block
2 x M10 buttoncap screws
2 x shakeproof washers
In the event of loss or damage, consult your dealer or the manufacturer.
Doc No:SM-137 Iss. C 13.02.13 6 Marlec Eng Co Ltd