Inhaltsverzeichnis
Werbung
Rutland 914i Windcharger
Further System Requirements
Total = 12v
In parallel to increase amp
Total = 24v
60Ah
12v
In series to increase voltage
Cable Specification
Cable
12V
Run
mm²
(m)
0-20
2.5
21-30
4
31-45
6
10
46-80
Doc No:SM-137 Iss. C 13.02.13
12 0Ah
14 40Wh
60Ah
12v
60Ah
12v
60Ah
14 40Wh
60Ah
12v
Cable Size
24V
AWG
mm²
AWG
13
1.5
11
2.5
9
4
7
6
Batteries
Leisure/Deep Cycle batteries are specifically
designed for good performance in terms of
charge/discharge cycles. Batteries are the most
important part of your battery charging system
and should be sized according to your load
requirements and provide at least 3 days
reserve capacity. This will reduce cycling,
prolong the life of the battery and ensure
system reliability during periods of low wind.
Permanent connections should always be made
to the battery terminals. Never use crocodile
clips or similar devices.
We strongly recommend that one of the voltage
regulators available from Marlec is fitted to
prevent batteries becoming overcharged in
strong winds and is essential with gel/sealed
batteries.
Batteries may be linked as shown in the figures
10 and 11. It is essential to observe polarity as
follows:
Red is
+ Positive
Black is - Negative
The cable used for connection of the
Windcharger to the batteries should be in
accordance with table 1. The use of a
smaller cable than recommended will
15
reduce the performance of the charging
13
system.
11
Cable and connectors are available from
9
your dealer or the manufacturer.
16
Installation & Operation
Marlec Eng Co Ltd
Werbung
Inhaltsverzeichnis
Fehlerbehebung
