Land Based Systems - Marlec Rutland 914i Windcharger Bedienungsanleitung

Rutland 914i Windcharger
Centre pivoted pole
Base pivoted with gin pole
Doc No:SM-137 Iss. C 13.02.13

Land Based Systems

Fig. 9
The Rutland 914i is suitable for some land based
temporary and leisure applications. The Furlmatic
Windcharger model is recommended for land
based remote and exposed locations.
The Rutland 914i is designed to fit inside
aluminium, stainless or steel tube with an internal
diameter of 41mm. (1�").
external diameter MUST NOT exceed 48.5mm
(1�), see Warning in Introduction.
A suitable mounting pole can be erected using a
6.5 metre (21 feet) galvanised (medium) tube.
The tube must be supported by a minimum of four
Fig. 10
guy lines. The attachment points for the guy lines
to the tower should be securely fixed to the tower.
The guy wires should be a minimum of 4mm
��
(0.16") in diameter.
The shackles should be a minimum of 5mm
��
(0.20") in diameter.
Rigging screws should be a minimum of 5mm
��
(0.20") in diameter.
All items should be galvanised or stainless
��
steel for protection against corrosion.
Where guy lines are looped, the loop must
��
incorporate a thimble and be fitted with a
minimum of three rope grips.
All ground fixings must be made suitable
��
according to the terrain.
We suggest pivot type towers as these allow for
easier installation and lowering for access to the
wind generator. Two forms of pivot tower are
suggested in Figs 9 & 10.
A base-hinged 6.4m tall Land Tower Kit (Part
No: CA-12/08) and Rigging Kit (Part No:CA-
12/07) are available from Marlec.
15
Installation & Operation
IMPORTANT: The
Marlec Eng Co Ltd