Electrical Safety; Description Of Machine Parts; Bar And Chain Assembly; Lubrification System - Wolf Garten CSE 2240 Bedienungsanleitung

4. ELECTRICAL SAFETY

# Voltage: make sure your machine is correct
for your mains supply
# Current: your machine is suitable for AC
supply only.
# Plugs/extension leads: we recommend the
use of PVC or rubber covered plugs, connectors
and leads with your machine.
# Power point: the machine must be connected
to a power point and not a lighting
socket.

5. DESCRIPTION OF MACHINE PARTS

The package contains the following items:
1. Rear handle
2. Lock off safety button
3. Start lever
4. Chain oil tank
5. Bar with toothed pinion
6. Chain
7. Front handle
8. Air intakes
9. Power supply cable with plug
10. Brake-hand guard engaging lever
11. Chain guard
12. Bar locking hand wheel + chain tension
adjustment hand wheel
13. Bar locking pin
14. Chain pinion
15. Oil tank inspection gauge
16. Spiked bumper
17. Cable strain relief
NOTE: make sure that the power tool and
accessories in the package are not damaged
NOTE: read these operative instructions
carefully before attempting to operate the drill

6. BAR AND CHAIN ASSEMBLY

FIG. 1 - 2 - 3 - 4 -5 - 6
# Check that the chain brake (10) has not been
engaged, and the brake lever is in position '1'.
# Unscrew the bar locking hand wheel (12) and
also remove the chain guard (11).
# Fit the bar (5) onto the locking pin
(13). Turn the adjustment flange in the direction
shown by the arrow of fig. 5, then push the bar
back all the way toward the pinion (14).
# Slide the chain (6) through the bar slot,
starting from the top section, making sure that
the teeth cutting edge is facing forward, on the
blade top side.
# Fit the chain around the pinion (14).
# Fit the chain guard and partly tighten the bar
locking hand wheel (12) by hand, as shown
in fig.6.
# Tension the chain by using the chain tension
adjustment hand wheel (12), fig. 7.
The tension is correct when the chain remains
inside the slot around the bar and can be turned
with the fingers. At this stage, fully tighten the
bar locking hand wheel, as shown in fig. 8.
# Too much tension on the chain will reduce the
life of the chain, the bar and the engine.
# Too little tension of the chain may cause
the chain to fall from the bar, and create a
dangerous condition for the user.
7. LUBRIFICATION SYSTEM
FIG. 10
# An automatic pump allows the chain
lubrication.
# Use only new oil for chains. The choice of the
oil viscosity depends on the air temperature.
Never use waste oil or second rate oil that could
damage the pump, the bar and the chain.
# Contact an authorised service centre in order
to choose good oil.
# Never use the chainsaw without oil. Check oil
level regularly, refill if less than ¼ full.
# If the lubrication system doesn't work properly,
check that the oil filter is clean, eventually
contact an authorised service centre.
29