Program The Receiver Collar For Two Or Three-Dog Operation - Petsafe 400 m Trainer Betriebsanleitung

Program the Receiver Collar for Two or
Three-Dog Operation
With the Transmitter set to Mode 3 or 4, PetSafe
to the upper, lower, or side Remote Transmitter buttons. Add-A-Dog
purchased to train additional dogs.
1. Program the Remote Transmitter to Mode 3 or 4.
2. Program the fi rst Receiver Collar.
A. Turn the Receiver Collar off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on, then
turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver Indicator
Light will begin its normal fl ashing. If this occurs, start over and repeat the process.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1 m from each other.
If the Receiver Indicator Light does not fl ash 5 times, start over and repeat the process.
3. Program the second Receiver Collar using A. through D. above, but using the Lower
Button in place of the Upper Button.
4. Program the third Receiver Collar using A. through D. above, but using the Side Button
in place of the Upper Button.
12 www.petsafe.net
® Receiver Collars can be set to respond
™ receiver(s) must be