Inhaltsverzeichnis
Werbung
2
1
Figure 9 Power Connector
Mating Connector: Amphenol-Tuchel
16T3109001 (Female) Philips #3152525-900.
6.8.2
Control Connections: LTC 9488/50C only
1. Inside housing, mate lens connector to female connector
located inside of housing. Internal connector is prewired to
the external 14-pin Amphenol Connector.
2. External Wiring: Control wires 35 to 24 AWG should be
used. Strip 2.5–3 mm of insulation away from wire. Next,
insert each stripped wire into provided socket and crimp to
secure wire.
3. Insert pin sockets into the black receptacles located on the
provided female connector (see the following below for
correct wiring configuration) and mate to the male
connector located on the back of the housing (see Figure 8).
Then, utilize supplied parts to protect wires.
Figure 10 Control Connector
Mating Connector: Amphenol-Tuchel
C016 10E014 0021 Philips #3153502-900.
3
G
The following table refers to Figure 10.
LTC 9488/50C only:
Pin
Function
4
Zoom Wipeer
5
Pot Return
6
NC
2
7
Focus, Wiper
8
Pot Supply
9
NC
10
Focus - Far
11
Focus - Near
12
NC
13
Zoom - Wide
14
Zoom - Tele
1. Color codes indicate harness wire color.
2. NC - No connection, Do Not Use.
6.9
Video Coax Connection
WARNING: Only use the cables specified under
"INSTALLATION, Cable Requirements" for wiring
of the video coax connection.
1. A video connection is provided on the rear of the housing.
Connect video cable to housing using a BNC connector.
2. An internal video connection is provided. Simply connect
the BNC cable to the camera.
6.10 Camera/Lens Adjustment
1. Verify camera and lens operation before final assembly of
the cradle into the housing. Adjust the camera focus and
iris as necessary. See individual camera instructions.
6.11 Final Assembly
1. Reinstall the cover. Align the bottom of the cover ribs with
the top of the base. Slide the cover onto the base. Make sure
the seal is not folded over or torn. Use silicone grease to
lubricate the seals if necessary. See Figure 11.
Figure 11: Reinstalling the Cover
2. As the cover nears the rear cap, make sure the captive screws
in the back are not blocking the cover from engaging into
the rear cap.
3. Screw the two rear captive screws into the housing.
9
Color
1
Pink
Gray
--
Light Blue
Orange
--
Blue
White
--
Green
Red
Werbung
Inhaltsverzeichnis
