Inhaltsverzeichnis
Werbung
Camera
Bracket
Figure 3: Removing the Camera Bracket
2. Remove the camera bracket from the base.
Mounting fixed lens cameras in LTC 9483 Series
Housings
3a. Attach the lens to the camera.
3b. Use the 1/4-20 x 3/8-inch screw to mount the camera to the
camera bracket. The lens should extend approximately 6
mm (0.25-in) from the front of the camera bracket. See
Figure 4.
Camera
1/4-20 × 3/8 Screw
Figure 4: Attaching the Camera
Loosen These Screws
Camera
Bracket
6.4 mm
0.25 in
Mounting LTC 0330/x1, LTC 0350/x1, LTC 0430/x1, and
LTC 0450/x1 fixed lens cameras in LTC 9480, LTC 9483
Series Housings
3c. Remove the mounting block from the camera by removing
the two small screws that attach the foot to the camera. Use
a small straight blade screw driver to remove these screws.
See Figure 5.
Camera
Foot
Figure 5: Removing the Camera Foot
3d. Attach the lens to the camera.
3e. Mount the camera to the camera bracket using the two
screws removed from the foot. Use the slots in the camera
bracket to accomplish this. See Figure 6.
Note: The hardware kit contains a spacer block. This spacer
block can be used to raise the camera off the camera bracket.
Simply place the spacer block between the camera and the
camera bracket and through the screws. This is only necessary in
very few instances when the lens may hit the camera bracket.
Figure 6: Mounting the Camera
7
Camera
Camera Screws
Werbung
Inhaltsverzeichnis
