Inhaltsverzeichnis
Werbung
Cable Size:
Outside diameter between
4.6 mm (0.181-in) - 7.9 mm (0.312-in).
Cable Shape:
Round.
Shield:
> 93% Braided Copper Shield.
Center Conductor:
Stranded Copper Center.
DC Resistance:
< 15 Ohms/1000 (RG-59/U).
< 6 Ohms/1000 (RG-11/U).
Cable Impedence:
75 Ohm.
Agency Rating:
UL, CE.
Environmental:
Outdoor rated.
Temperature Rating: > 80 °C.
Sources:
Belden 9259.
Belden 9238.
Input Power Cord - North American
Cable Type:
SJTOW-A rated.
Cable Size:
Outside diameter between
4.3 mm (0.170 in) - 11.9 mm (0.470 in).
Cable Shape:
Round.
Conductors:
3 conductor version and
2 conductor version.
Agency Rating:
UL/C.S.A., UL VW-1.
Environmental:
Outdoor rated.
Temperature Rating: 105 °C.
Voltage Rating:
300 V.
Sources:
Belden 19506.
Belden 19509.
Northwire 573939.
Input Power Cord - European
Cable Type:
H05RN-F3G0.75 and
H05RN-F3G1.00.
Cable Size:
Outside diameter between
9.5 mm (0.374 in) –13 mm (0.512 in).
Cable Shape:
Round.
Conductors:
3 conductor version and
2 conductor version.
Agency Rating:
VDE.
Environmental:
Outdoor rated.
Sources:
Olflex 1600252.
Olflex 1600253.
Lens Control Cable
Cable Type:
Jacketed Multiconductor Cable.
Cable Size:
Outside diameter between
11 mm (0.433 in)–13 mm (0.512 in).
Cable Shape:
Round.
Shield:
Overall shielding.
Conductors:
35 to 24 AWG.
No. of Conductors: 14 total, 8 used.
Conductor
Insulation:
Color coded.
Sources:
Amphenol-Tuchel: 14-pin +PE.
6.5
Housing Mounting
1. Use the two 1/4-20 x 0.50-inch screws and 1/4-in spring
washers provided in the hardware kit to mount the housing
to a mount or a pan/tilt. The spring washers must be used
for the screws to thread properly.
2. The outer most set of 1/4-20 threaded holes are for
mounting to feed-through mounts and the inner most 1/4-
20 holes are for mounting to all other mounts and pan/tilts.
6.6
Cover Removal
1. Loosen the top two screws on the rear of the housing. These
screws are captive and will not come out all the way. Do not
remove the bottom two screws. See Figure 1.
Figure 1: Loosening Captive Screws
2. Grasp the housing's front cap and pull forward. Do not
squeeze the cover itself. This will make it difficult to slide off
the cover. See Figure 2.
Figure 2: Removing the Cover
3. The cover is attached to the base. Allow the cover to dangle
from the base.
6.7
Camera/Lens Installation
1. Loosen the two screws holding the camera bracket to the
base. It is not necessary to remove them completely. See
Figure 3.
6
Loosen these screws
Do not remove
Werbung
Inhaltsverzeichnis
