Hama 00040074 Bedienungsanleitung Seite 7

5.3 Auto Code Search
Auto Code Search uses the same preloaded codes as the Manual Code Search
(5.2) but your Universal Remote Control scanns through the codes automatically
until the device you want to control shows a reaction. This might be that the
device you want to control switches off ( [POWER] key ) or changes the channel
( [Ch+/Ch-] keys ).
5.3.1 Turn on the device you want to control
5.3.2 Press the [SETUP] key until the LED indicator is permanently lit.
5.3.3 Select the device you want to control using the device key ( e.g. [TV] ). A
successful selection is indicated by the LED with one ash followed by
permanent light.
5.3.4 Press the [Ch+/Ch-] keys or [POWER] to start the Auto Code Search. The
LED indicator ashes once followed by permanent light. The Universal
Remote Control has a latency of 6 seconds before the rst scan starts.
Note: Scan Speed Settings
• Scan Speed Settings can be set at either 1 or 3 seconds. The default setting
for the scan time per single code is 1 sec. If this feels uncomfortable , you
can switch to 3 sec. scan time per single code. To switch between the scan
times, press [Ch+] or [Ch-] during the 6 sec. latency before Auto Code
Search starts scanning.
5.3.5 The LED indicator con rms each single code scan with a single ash.
5.3.6 Press [SETUP] key to save the code and exit the code search. The LED
indicator turns off.
5.3.7 To stop the Auto Code Search during the scan process, press the [EXIT] key.
Note
• When all codes are searched without success, the Universal Remoote Con-
trol exits Auto Code Search and returns to operational mode automatically.
Currently stored code is not changed.
5.4 Code Identification
The Code identi cation offers you the possibility, to determine an already entered
code.
5.4.1 Press the [SETUP] key until the LED indicator is permanently lit.
5.4.2 Select the device you want to control using the device key ( e.g. [TV] ). A
successful selection is indicated by the LED with one ash followed by
permanent light.
5.4.3 Press [SETUP] key. The LED indicator ashes once followed by permanent
light.
5.4.4 To nd the rst digit, press the numeric keys from [0] to [9]. The LED
indicator ashes once to indicate the rst digit of the 4-digit code number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth digit.
TV
DVD
CODES
VCR
AUX
STB
DVBT
5