Hama 00040074 Bedienungsanleitung Seite 10

Note
• Do not move the remote controls during the learning procedure.
• Ensure that the room is not lit by uorescents tubes or low energy con-
sumption lamps since such light sources could interfere with the copying.
• The 2 remote controls must be at least
1 meter away from any light source.
• During learning mode, if no key is selected for more than 30 seconds, the
learning mode will exit automatically or
if no other remote signal is received.
• Each function key will hold only one command. A new command to be
learned will automatically replace the previous one.
• It is not possible to learn any new functions to the [TV], [DVD], [STB], [VCR],
[AUX], [DVBT] and [SETUP] key.
7.2 ENTER LEARN MODE
7.2.1 Press and hold the [MUTE] and [Vol+] keys for approx. 3 seconds until the
LED will be lit.
7.2.2 Select the device you want to learn a command using the device key ( e.g.
[TV] ). A successful selection is indicated by the LED with one ash followed
by permanent light.
7.2.3 Enter the code [9] [8] [0], the LED will ash
2 times and then remain on.
7.2.4 The Universal Remote Control is now ready to learn new commands.
Note
• If the LED indicator ashes eight times and exits the learning mode
automatically, it means you have learned too many buttons and ran out of
storage space. The remote can store max. 125 learned keys.
• If no device selected, it will consider current device as default.
7.3 LEARNING OF KEYS
7.3.1 Press and release the desired key on the original remote control which
you want the command to be learned. The LED at your Universal Remote
Control will ash to con rm that the information has been received.
7.3.2 Then press and release the target key on the Universal Remote Control you
want learned.
7.3.3 If the LED ashes 3 times and then remain on, the command has been
learned successfully.
7.3.4 Repeat these steps to learn other key functions.
7.3.5 Please press the [SETUP] key to save the code and exit learning mode.
8