Fluval Roma Benutzerhandbuch Für Die Strip-Light-Abdeckung Seite 5

If the plug or socket does get wet, DON'T unplug the cord. Disconnect the fuse or circuit breaker
that supplies power to the appliance. Then unplug and examine for presence of water in the wall
socket.
3. Close supervision is necessary when any appliance is used by or near children. Do not allow children
to use this appliance. This appliance is not a toy.
4. To avoid injury, do not come into contact with moving parts or hot parts such as heaters, reflectors,
lamp bulbs, etc.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before
placing hands in water, before putting on or taking off parts and whilst this STRIP-LIGHT is being
installed, maintained or handled. Never yank cord to pull plug from outlet. Grasp the plug and pull to
disconnect. Always unplug an appliance from an outlet when not in use.
WARNING: The line cord Switch on the Strip Light cannot be considered a safety switch.
6. Do not use an appliance for other than intended use (i.e. don't use on swimming pools, garden ponds,
bathrooms, etc.). The use of attachments not recommended or sold by the appliance manufacturer
may result in a dangerous situation.
7. IMPORTANT: This is a non submersible AQUARIUM LUMINAIRE (STRIP LIGHT) suitable FOR
INDOOR USE ONLY designed to be assembled onto FLUVAL ROMA Top Cover Frames Only. For
Fresh and salt water aquariums with max 35 °C water temperature. Do not install or store the appliance
anywhere where temperatures may drop below freezing.
8. IMPORTANT: Make sure that the STRIP-LIGHT is securely and correctly installed before operating it
and that the minimum distance of water from the Strip-Light is 15 mm. This STRIP-LIGHT must never
operate in water.
Fill the aquarium up to level indicated on the label situated
on the inside of the aquarium's top frame.
IMPORTANT: Do not over fill. Overfilling the aquarium
can cause water to pass under the top frame which
then runs down the outside of the aquarium.
WARNING: The safety of this Strip-Light can only be guaranteed provided that both lamps are
inserted and that all threaded fittings are properly installed.
WARNING: Do not plug in the canopy if there is water on parts not intended to be wet.
WARNING: Do not place any object(s) on the canopy. Ensure sufficient air space around the
canopy. The safety of this appliance is only ensured provided that it has been properly installed.
9. Read and observe all the important notices on the appliance.
10. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less
amperes or watts than the appliance rating may overheat. Care should be taken to arrange the cord so
that it will not be tripped over or pulled.
11. IMPORTANT: Use only standard aquarium normal output fluorescent bulbs as per the rating
characteristics indicated on the electrical data label located on the Strip-Light.
12. IMPORTANT: supply all appliances through a RCD (Residual Current Device) or GFCI (Ground
Fault Circuit Interrupter) with rated residual current not exceeding 30mA.
Fluval Roma instructions.indd 5
5
09/07/2007 17:09:18