Explanation Transmitter - Carson Micro X-Warrior Bedienungsanleitung

Explanation transmitter

Gear indicator lamp
Shift up
Power switch
Mode conversion button
Trim Steering
Charging head
Select speed steps:
Especially for beginners, it is advantageous if the model don´t have
the full power of throttle from the beginning.
You can set the limit of throttle in 5 steps. For this purpose, you must
be set the speed limit-switch to „Mode 5".
Then you can choose between:
LEVEL 1 = 20%
LEVEL 2 = 40%
LEVEL 3 = 60%
LEVEL 4 = 80%
LEVEL 5 = 100%
If the switch is set to „ALL SCALE MODE" so the throttle is activated to
100%. The indicator LEDs indicate the adjusted step.
Trim Steering:
If your model runs not straight in the neutral position of the steering
wheel, you can use the trim button on the transmitter for adjusting.
The vehicle go to the left, turn the trim knob so long to the right until
the model is running straight. If the vehicle got to the right, turn the
trim knob so long to the left until the model is running straight.
Trim throttle:
If your model runs forward or reverse when the trhottle-lever is in
the neutral position, you can use the trim button on the transmitter
backside to adjust the zero point. Turn the knob trim as long to the
right or left until the model stops in the neutral position.
CARSON 1:32 MICRO X-WARRIOR 2WD/GHz 100% RTR 500404079
2.4 GHz Antenna
Rotating button
Power switch
Handle Forward and
On/Off
Backwards
Forward / Backward
trimming
Battery compartment
15