Sygonix 420 TVL Bedienungsanleitung Seite 3

Operating instructions
GB
CCD Colour Camera, 420 TVL, 3.6 mm
Intended use
This camera is intended for installation in, monitoring and protecting, secluded or criti-
cal areas (e.g. entrance areas, surveillance of underground car parks and the like).
The camera is only intended to be used with a stabilised mains voltage of 12V/DC.
The product is designed for use indoors and outdoors (IP65).
Please bear in mind that it is prohibited by law to observe strangers with a camera
without their knowledge and consent. Observe the rules and regulations of the coun-
try where you are using the camera.
The safety instructions must be observed at all times!
Any other use than that described above may damage the product. Moreover, this
may give rise to hazards such as short-circuiting, fi re, electric shock, etc. No part of the
product may be modifi ed or converted!
This product complies with the applicable National and European requirements. All
names of companies and products are the trademarks of the respective owner. All
rights reserved.
Package Contents
• Colour camera
• Mounting material (screws/wall plugs)
• Allen key
• Operating Instructions
Explanation of the Symbols
This symbol indicates specifi c risks associated with handling, function and
use.
The "arrow" symbol indicates special tips and operating information.
Safety Instructions
The warranty will be void in the event of damage caused by failure to ob-
serve these safety instructions! We do not assume any liability for any
consequential damage!
Nor do we assume liability for damage to property or personal injury
caused by improper use or failure to observe the safety instructions. In
such cases, the warranty will be null and void.
• The unauthorised conversion and/or modifi cation of the product is not per-
mitted for safety and approval reasons (CE). Never dismantle the product.
• The camera is only intended to be used with a stabilised direct current of
12 V/DC. The inner contact of the round plug should be Plus/"+", the outer
contact Minus/"-".
• The product is not a toy and must be kept out of the reach of children. It
should be operated out of the reach of children.
• The use of the surveillance camera system does not replace the personal
supervision of children, or people who require special assistance, but only
serves as a support to this supervision.
• The camera is suitable for use in indoor and outdoor areas (IP65). However,
it must never be used in or under water, as this will destroy it.
The plugs on the camera's connection cable are not waterproof or water-
tight and, therefore, must be placed in a dry indoor area.
The home technology brand for the entire house. More information at www.sygonix.com
• The camera may not be exposed to extreme temperatures, direct sunlight,
strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not pinched or damaged by sharp
edges.
• Do not leave packaging material carelessly lying around since it could be-
come a dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or ac-
cidental drops, even from a low height.
• If the camera is used with other devices (e.g. a monitor), the operating in-
structions and safety notices for these devices must be followed.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device no longer works
- the device has been stored under adverse conditions.
- it was exposed to heavy loads during transport
• In commercial institutions, the accident prevention regulations of the Em-
ployer's Liability Insurance Association for Electrical Systems and Operating
Materials are to be observed.
• If you have any questions that are not answered in this manual, please con-
tact our technical service or another specialist.
Installation
• Remove the two set screws of the retaining ring, using the provided Allen key.
After this, remove the retaining ring.
• For the connection cable, an appropriately large hole can be drilled at the mounting
site (when you plug the jack, protect it against dust and dirt with something like a
piece of tape).
• The retaining ring can be secured at the mounting site with 4 screws. Use suitable
screws and wall plugs, depending on the surface.
Make sure when screwing into place or when drilling holes that cables or wires
are not damaged.
• Place the camera in the holding ring and secure it with the set screws removed at the
beginning.
Important:
The adjustment or direction of the camera is carried out by loosening the two
set screws a little way.
Then the spherical camera can be directed toward the monitoring area.
Finally, screw in the two set screws again fi rmly.
The camera should not be pointed directly towards bright sources of light or
the sun, since this will overexpose the image.
For outdoor use we recommend to choose a location that is protected from
rain (e.g. under the eaves) to prevent the formation of droplets on the cam-
era's front panel that will cause a distorted and unusable image.