Bosch BSG8PRO1 Gebrauchsanweisung Seite 17

en
4*
Figure
Press the adjusting sleeve in the direction
of the arrow and adjust the telescopic tube
to the length required.
5
Figure
Holding the power cord by the plug, pull out
the required length and plug the plug into the
mains socket.
6
Figure
To switch your vacuum cleaner on and off,
press the On/Off button in the direction of
the arrow.
Vacuuming
You have bought an extremely powerful
device. The highest suction setting is there-
fore only recommended for heavily soiled,
short-pile carpets and hard floors.
7
Figure
The required suction power can be selected by
adjusting the suction regulator.
Low
suction range:
For vacuuming delicate fabrics, e.g. cur-
tains.
Moderate
suction range:
For daily vacuuming of lightly soiled floors.
High
suction range:
For vacuuming durable floor coverings,
hard floors and for heavily soiled surfaces.
Turbo range:
For vacuuming stubborn dirt and very heavily
soiled surfaces.
8
Figure
Adjusting the floor tool:
a) For vacuuming rugs and carpets
b)For vacuuming hard floors
* Dependent on model
12
Turbo brush
If your vacuum cleaner is equipped with a
turbo brush, please consult the
accompanying instruction manual for notes
on its use and maintenance.
Vacuuming with accessories
Figure
Remove the accessory from the case and
attach to the handle or suction pipe.
a) Professional crevice nozzle
b)Professional furniture brush
c) Professional upholstery nozzle
After use, the professional accessories can
again be conveniently stowed in the
accessories case.
=>
=>
9
Extra long crevice nozzle for cleaning
crevices, corners and narrow spaces, e.g.
in a car.
For large-surface vacuuming of furniture
requiring particular care, picture frames,
books, etc.
For gently and thoroughly cleaning
upholstered furniture, curtains, etc.
To clean the professional upholstery
nozzle, simply vacuum using the handle.
If it is very dirty, the professional upholstery
nozzle can also be opened.
To do this, turn the two screws on the
sides of the nozzle (e.g. using a coin) and
remove the inner part from the nozzle. After
cleaning, replace the inner part (make sure
it is correctly seated) and screw to the
housing.