Renkforce 752168 Bedienungsanleitung Seite 46

• Activate a sensor in alarm zone 2. The exit delay (approx. 30 seconds) com-
mences now. If the signal sounds are activated, they are issued. The status
LED "EXIT" also flashes slowly. After the end of the entry delay, the alarm is
triggered and the status LED "EXIT" is permanently lit
• The alarm can be terminated at any time and the alarm system be disarmed by
setting the "mode selection switch" to "OFF".
The system can also be disarmed by an external key switch.
Perform the system test again to test the alarm zone 1 sensors.
46