Renkforce 751781 Bedienungsanleitung Seite 42

Load capacity of outputs:
Relay 1
Relay 2
Sabotage contact
EG IN (Egress)
Output 1
"Access control"
(cable 13)
Control output for
Two-door system
(cable 14)
Key-Alarm
(cable 8)
Zwangsmelde-
kontakt "DURESS"
(cable 16)
"EGRESS contact" (if this terminal is connected to the ground potential then relay 1
switches according to your programming.)
This contact is useful when you wish to open a door from the inside that is controlled
by relay 1.
The following table describes the connections in the connector strip (1) and gives ex-
planations.
In alarm systems there are two types of contact, designated with "NO" and
"NC".
NO Normally Open: The contact is normally open when not activated
NC Normally Closed: The contact is normally closed when not activated
42
30 V (AC/DC), 5 A
30 V (AC/DC), 1 A
Current-free NC contact for a 24 h alarm loop
NPN open-collector contact, 100 mA / 24 V/DC;
switches in the event of a minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA;
switches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA;
switches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA;
switches to minus potential (-)
NPN open-collector contact, 24 V/DC, 100 mA;
switches to minus potential (-)