Schego schegoLUX-spot Bedienungsanleitung Seite 18

schegolux.book Seite 18 Dienstag, 29. Juni 2010 5:30 17
Placing the schegoLUX~spot
Placing the schegoLUX~spot
With floor mounting
1. Drill a hole into the subbase and insert a suitable dowel into the hole.
NOTE:
The brass dowel (Fig. 1/9) included in the scope of delivery is most suitable for
subbases consisting of wood or stone. If you use the brass dowel in a very hard material
(e.g. granite) you must make sure that the dowel is inserted for at least 10 mm.
2. Place the round recess in the floor base (Fig. 4/1) above the drilled hole and fasten the
spotlight with a screw (not part of the delivery).
NOTE:
In case of too lose subbases assembled the floor base on a stone or heavy slab and
then move the assembled spot to the desired location.
With floor plate
ATTENTION:
The spotlight works with electric current. Water entering into the housing can damage
spotlight and transformer. Before submerging the spotlight in the water, check
whether locking ring and spotlight housing are tightly screwed on and that all seal
rings are in place.
1. Choose a flat location in your pond.
2. Lower the spotlight with floor plate down to this place and load the floor plate with
a suitable weight, e.g. a stone.
With spit
1. Check the strength of the subbase.
ATTENTION:
In case of too loose soil the spot may tip over, with too dense soil the spit may be
damaged. In these cases we recommend the use of a floor base.
2. Insert the spotlight with spit directly into the ground at the desired location and
check its stability.
18