Conrad 9822 Bedienungsanleitung Seite 13

Installation
Bloc de raccordement
36
Removing the front cover
1. Release the securing bolt by unscrewing it counterclockwise
using an appropriate screw-driver.
2. Now push the front cover's locking mechanism in slightly using
the tip of the screwdriver, while lifting the front cover off!
Removing the printed circuit board
Before mounting the housing rear panel, make sure that the pcb is
removed from the housing!
1. Use an appropriate screw-driver to release the securing bolt.
2. Now push the pcb upwards until the screw head fits through the
slot (borehole) on the side of the the pcb.
3. Next, remove the pcb carefully from the housing.
25