Vibration - Evolution FURY3-XL Original Instructions

www.evolutionpowertools.com
as well as producing general numbness.
Prolonged or regular users of mitre saws should
monitor the condition of their hands and fingers
closely. If any of the symptoms become evident,
seek immediate medical advice.
a. The actual vibration level during use will
depend on the workpiece stability/rigidity
and the condition of the cutter being
used. These factors may increase the vibration
experienced by the operator. Each individual
application of the tool should be assessed for
the effect of these application variable factors,
before exposure.
b. The measurement and assessment of
human exposure to hand-transmitted
vibration in the workplace is given in:
BS EN ISO 5349-1:2001 and
BS EN ISO 5349-2:2002
c) The following factors can influence the
level of vibration. Reducing these factors will
help to reduce the effects of vibration:
Handling:
• Handle the machine with care, allowing
the machine to do the work.
• Avoid using excessive physical effort on
any of the machines controls.
• Consider your security and stability, and
the orientation of the machine during use.
workpiece:
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
wARNING:
The vibration emission during
actual use of the power tool can differ from the
declared total value depending on the ways
in which the tool is used. The need to identify
safety measures and to protect the operator
are based on an estimation of exposure in the
actual conditions of use (taking account of all
parts of the operating cycle, such as the times
the tool is switched off, when it is running idle,
in addition to trigger time).
(1.8)
SAFETY LABELS & SYMBOLS
wARNING:
Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note: All or some of the following symbols
may appear in the manual or on the product.
Symbol Description
V
A
Amperes
Hz
Min (RPM)
-1
~
Alternating Current
n
No Load Speed
o
Wear Safety Goggles
Wear Ear Protection
Do Not Touch, Keep Hands Away
Wear Dust Protection
Wear Safety Gloves
Ce Certification
Waste Electrical And
Electronic Equipment
Triman - Waste Collection
& Recycling
Read Manual
Warning
Laser Warning
LASERLICHT
NICHT IN DEN STRAHL BLICKEN Never look into the laser beam.
LASER KLASSE 2
A: 650nm: P ≤ 1mW
EN 60825-1: 2007
Direct laser beam may injure your eyes.
Double Insulation Protection
9
Volts
Hertz
Speed
EN