Commissioning The Docking Station With A Ps3; A) Product Installation; B) Functional Check; C) Connecting The Joypad - Conrad 90 29 98 Bedienungsanleitung

7. Commissioning the docking station with a
PS3™

a) Product installation

Connect the two USB connecting cables (bottom of docking station) to the two free
ports on the PS3™.
Activate the PS3™.
Both USB connecting cables must be connected to the PS3™ to
ensure that the docking station is powered correctly.

b) Functional check

After activating the PS3™, the green LED will light up on the basis panel and after a
few minutes, the red LED will begin to flash. This means that the system was ini-
tialised.
The red LED indicates that the console is reading data from the hard drive. At the
same time the 4 red status LEDs will begin to flash. These indicate which channel is
being used by the controller.

c) Connecting the joypad

Connect a PS2™ joypad to the port labelled "CONVERTOR".
Press the ANALOG key.
Please note that you will have to press the ANALOG key each
time you remove the USB connections on the docking station
from the PS3™ or whenever die PS3™ is restarted.
On the PS3™, the ANALOG key on the PS2™ controller corresponds to the PS key
on the PS3™ controller. Keep the ANALOG key pressed down for around 2 sec-
onds to enable the PS3™ to recognise the controller. Some functions on the PS2™
controller may not work on the PS3™ under certain circumstances.
21