Setting The Address Of Several "Es-4 - VOLTCRAFT ES-4 Bedienungsanleitung

8. Setting the address of several "ES-4"

The base unit "Energy Control 3000 USB" can receive a total of up to four
"ES-4" sensors. To that effect, an address space from 1 to 12 is available.
Based on the corresponding addresses, the base unit detects the sensor
type.
Address 1...4:
Address 5...8:
Address 9...12:
To set the address of the gas meter sensor proceed as follows:
• Press both "S1" and "S2" buttons simultaneously for approximately 2
seconds until the status LED lights up.
• As soon as you release the button, the status LED starts to blink
intermittently. The blinking indicates which address is currently active:
Blinking 1 x: Address 9
Blinking 2 x: Address 10
Blinking 3 x: Address 11
Blinking 4 x: Address 12
• By briefly actuating the "S2" button, you switch to the next higher address
or from address 12 back to address 9.
• After selecting the desired address, press "S1" to confirm and store the
newly set address.
• The latter will be communicated to the receiver with the next transmis-
sion.
32
Energy sensor "ES-2"
Socket sensor "ES-1"
Gas meter sensor "ES-4"