Hama Safety Bedienungsanleitung Seite 5

g Operating Instruction
Safety and usage precautions
1. The inverter is only intended for use in vehicles.
2. Use the inverter with intended on-board networks
(12 V) only. Never use them in 24 V networks. If in
doubt, consult the manual for your vehicle or contact
the manufacturer.
3. For best results and safest operation, the inverter
should ideally be placed in a drink holder in the
vehicle. If this is not possible, please ensure that the
inverter is operated on a stable and dry surface.
4. Keep the inverter dry. Never expose the inverter to rain
or moisture.
5. Avoid using the inverter in the immediate vicinity of
the heating outlets or other heat sources.
6. Ensure that the power supply unit is sufficiently
ventilated and that heat can dissipate adequately.
7. Never open the device.
8. As with all electrical devices, this device should be
kept out of the reach of children.
9. Should any of the following happen, do not use the
device under any circumstances and contact your
dealer or our service department immediately:
– The connection socket, connecting cable or plug is
damaged.
– The housing of the inverter is damaged.
– The device is defective, i.e. there is no output voltage
even if you are sure that none of the abovementioned
safety circuits have been triggered.
– If you see smoke, smell odours or hear unusual noises
from the device
Send the device to the following address with a precise
description of the fault if it requires service:
Hama GmbH & Co. KG
Abt. Service
Industriestr. 10
86653 Monheim
Germany
Hama GmbH & Co. KG shall not accept any liability arising
from improper use of the inverter or failure to observe the
above safety instructions.
Specifications:
Rated input voltage
Input voltage range
Input side connection
Continuous output capacity
Peak output capacity
Output side connection
Output voltage
Output frequency
Output voltage stability
Signal form (output side)
Efficiency
Idle current consumption
Thermal protection circuit
Short circuit protection
"Soft-start" start switch
Overvoltage protection
Low voltage protection
Polarity reversal protection
Residual current
deactivation
Fuse
Ambient operating
temperature
Dimensions
Weight
Hi-Pot**
* Prevents voltage peaks when switched on
** Isolation test performed in unit test.
12 V DC
9,5V – 15V DC =
Cigarette lighter plug
100 W
280 W
Shockproof socket
230 V AC
50Hz (+/- 2Hz)
+/- 10%
Modified sine
85%
< 0.45A
60°C +/-10°C
Yes
Yes
15.0 V +/-1.0V DC
9.5 V +/- 0.5V DC
Via fuse
30 mA
15A
-15°C bis +50°C
160 x 70 x 70 mm
650 g
Yes
5