Tips & Notes; Technical Data - Conrad 41 35 03 Bedienungsanleitung

Cleaning
Before cleaning the device, disconnect it from the power supply. The use of a dry, soft, lint-free
cloth is sufficient to clean the product.
Do not use aggressive cleaning agents as these can cause discolouration.
Do not press too strongly on the surface, to prevent scratch marks.
Dust can easily be removed using a clean, long-haired brush and a vacuum cleaner.
Tips & Notes
a) USB3.0
• USB3.0 devices are backwards compatible. This means that the hard disk enclosure, with the
SATA hard disk installed, also works with conventional USB2.0 or slower USB1.1 ports,
though only at the maximum USB2.0 or USB1.1. speed.
• Depending on the hard disk in your computer, and the hard disk installed in the enclosure, as
well as the motherboard used, USB3.0 supports speeds that may exceed 100MByte/s!
• For USB3.0, the cable should be selected to be as short as possible to avoid a reduction in the
transfer speed.
• To connect the hard disk enclosure to a USB3.0 port on your computer, you must use a
USB3.0 cable (e.g. the one enclosed).
If you use a conventional USB2.0/1.1 cable, only the max. speed supported by USB2.0/1.1 can
be achieved and not the transmission speed supported by the USB3.0 cable.
• If you want to connect the hard disk enclosure via a USB hub, the latter must also support the
USB3.0 transfer mode, in order to achieve the maximum speed.
b) General
• The LED at the front lights up when the hard disk enclosure is switched on (Power LED
function) or it flashes during read/write access.
• USB devices can be connected and disconnected during operation.
You should, however, take into account that data may be corrupted or the operating system
may crash if the connection cable is disconnected while data are being transferred.
In Windows, an arrow symbol is displayed in the menu bar when the hard disk (or other USB
devices) is in use. Click this arrow symbol to „separate" the device, i.e. to terminate data trans-
mission, so you can disconnect the connection cable without risking the loss of data.
Disposal
Electrical and electronic products do not belong in the household waste!
Please dispose of the device when it is no longer of use, according to the current
statutory requirements.

Technical Data

a) Hard disk enclosure
Connection: ..........................................USB3.0
Hard disk suitable for installation: ........SATA, 8.89cm/3.5"
Dimensions (L x W x H): ......................approx. 200 x 116 x 32mm (without stand/rubber feet)
b) Wall plug transformer
Operating voltage: ................................100-240V~, 50/60Hz
Output:..................................................12Vdc, 2A
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240
Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or
the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2010 by Conrad Electronic SE.