Reset To Factory Default Settings - MADRIX Orion Bedienungsanleitung

Description Of Status LED Codes
STATUS
Powered off
Permanently green
Blinking green
STATUS
Powered off
Red +
blinking green
Fading between
red + green
Orange
STATUS
Powered off
Blinking green
STATUS
Green off
Green on
Orange on
Orange blinking

Reset To Factory Default Settings

In rare cases, you might need to do a reset to factory default settings:
Step 1) Disconnect all connections from the device (power, data, input).
Step 2) Use a suitable tool to press the reset button (between Port 1 and 2).
Step 3) Continue to press the reset button and supply power again over
'Power' or over USB.
Step 4) Continue to press the reset button and wait until all status LEDs
of the device flash repeatedly or wait 10 seconds.
Please note: Simply repeat these steps should the process fail.
STATUS LED POWER
Power not connected.  The device has no power.
Connected to power.  The power is on.
Bootloader activated.  Reset device / upload firmware.
STATUS LED USB
USB not connected.
Communicating over USB.
 Sending or receiving data over USB. The USB port works.
Connected to USB; Drivers installed correctly.
 No data is sent over USB.
Connected to USB; No drivers installed.
 Reinstall software and drivers or try a different USB port.
STATUS LED PORT 1
No data is sent.
Receiving data / changes.
 The input port works.
STATUS LEDS ETHERNET PORTS
10 MBit/s connected.
100 MBit/s connected.
Network connected.
Sending or receiving data.  The Ethernet port works.
STATUS LED PORT 2
No data is sent.
Receiving data / changes.
 The input port works.
12
EN