MADRIX Orion Bedienungsanleitung Seite 14

How To Install On DIN-Rails
Unmounting (Pictured Right)
Step 1) Pull the unlocking clip.
Step 2) Lift the lower part of the device from the
rail in an angle.
Step 3) Lift the device from the rail.
Using The MADRIX
You can mainly use 3 operating modes together with the MADRIX
 DMX-IN Via Art-Net
 DMX-IN Via Streaming ACN
 DMX-IN Via USB
In the MADRIX
®
– For USB, go to 'Preferences' > 'Options...' > 'Devices USB'
– For sACN, go to 'Preferences' > 'Options...' > 'Devices Network'
– For Art-Net, go to 'Preferences' > 'Device Manager...' > 'Art-Net'
Then, configure your devices and activate input in order to receive the data:
– Go to 'Preferences' > 'Device Manager...' > 'DMX Devices'
– Go to 'Preferences' > 'Device Manager...' > 'DMX Input'
For more information, please read the MADRIX
13
EN
Mounting (Pictured Left)
Step 1) Hook the device in an angle onto the upper
Step 2) Pull the unlocking clip.
Step 3) Press the lower part of the device against
®
Software, make sure to activate the correct drivers first:
edge of the rail.
the rail and let the clip snap into position.
Software
5 user manual.
®
Software:
®