Inhaltsverzeichnis
Werbung
12
Installation in locos without interface
© DiskArt™ 1988
Turn your loco upside down and check whether the bottom of
the gearbox is marked with a "D."
If you find the "D," carefully open this loco. Each loco presents
difficulties when opening. We recommend looking for exploded
diagrams of your loco at www.lgb.com. Connect the decoder
directly to the gearbox using its four wires. To do so, you first
have to remove the cables for the existing electronics from the
gearbox top. On the four pins on top of the gearbox, you find
the markings "gn" = green, "bn" = brown, "ws" = white, and
"ge" = yellow. This represents the colors of the decoder wires.
After you have done this, the loco already goes forward and in
reverse.
Now you can decide whether you would like to do an advanced
or a simple.
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
