NovoPress ACO401 Betriebsanleitung Seite 35

Regularly (before use, at the start of the working day) and when soiled
(Fig. 13)
• Check the press collar, adaptor jaw and device for visible defects such as damage,
material cracks and other signs of wear. If defects are found, do not use the device any
more. Replace it or send it to an authorised specialist workshop.
• Clean the press collar with compressed air.
• Lubricate the adaptor jaw pins.
• Spray the entire adaptor jaw with lubricant.
• Remove deposits from pressing contour (K).
• Clean press collar pressing contour (K).
• Completely coat pressing contour (K) with lubricant.
• Check that sliding segments (C) and shells (D) can move freely.
Recommended lubricant
- WD 40
- Brunox Turbo Spray
After every 50 pressing operations
Spray joints (G) of the press collars with lubricant.
Spray lubricant between sliding segments (C) and shells (D).
Bi-annually
Have the device inspected by a qualified electrician or a specialist Novopress workshop.
Annually
Have the press device inspected by a Novopress workshop.
29
ACO401
EN