Technical Data; Installation Instructions - Velleman K7200 Gebrauchsanweisung

0..30V/0..10A LABORATORY POWER SUPPLY
A laboratory power supply offers an indispensable set for both the professional
and the amateur.
This power supply is short-circuit protected and infinitely variable from 0 to 30V
and from 0 to 10A.
Both a digital voltage meter and a digital ampere-meter are supplied as
indicators.
Thanks to the in-built fan the power supply is able to cater for long-term full load.
Is supplied complete with housing, buttons and transformers.

TECHNICAL DATA

- Output voltage variable from 0v to 30V.
- Fine tuning over 1V
- Output current limiting device infinitely variable from 0 to 10A.
- LED (light emitting diode)-indication of current limitation
- Output current: 8A. continuous/10A. peak
- Short-cicuit protected
- Ripple maximum: 0.5mV RMS
- Digital voltage meter: 3-digit, 0.1V accurate
- Digital amperemeter: 3-digit, 0.01A accurate
- Consumption: 300W maximum
- Dimensions WxHxD: 330x90x215
We reserve the right to make alterations

INSTALLATION INSTRUCTIONS

VERY IMPORTANT
- MOUNT ALL COMPONENTS AGAINST THE P.C. BOARD
- USE A SMALL SOLDERING IRON OF 40W MAXIMUM
- USE THIN (1mm) SOLDERING TIN
- CARELESS ASSEMBLY WILL UNDOUBTEDLY CAUSE PROBLEMS
The power supply consists of four pcb's:
A base card with potentiometers that feature behind the front panel.
Two transistor boards on to which the power transistors, situated on the
heatsinks, are connected.
Finally, a board with digital voltage and ampere-meter.
A) Construction of the transistor PCB P7200T
The two PCB's are assembled differently:
H7200-ED2-23