Handling; Maintenance - Renkforce EQ-1000 Bedienungsanleitung

Handling

• Never plug the power plug into a mains socket immediately after the device was taken from a cold to a warm
environment. The condensation water created thereby may damage the device.
Allow the device to reach room temperature before connecting it. Wait until the condensation water has
evaporated.
• Never pull the mains plug by pulling the cable from the socket. Always only use the thus provided grip area.
• Remove the mains plug from the electrical outlet if the device is not in use for a longer period of time.
• For safety reasons always pull the mains plug from the socket during a thunderstorm.
• Do not listen to excessively loud music for long periods of time. This may damage your hearing.

Maintenance

Periodically check the technical safety of the device, e.g. check for damage to the power cable or the housing.
If you have a reason to believe that the device can no longer be operated safely, disconnect it immediately and secure
it against being operated unintentionally. Pull the power plug out of the socket outlet!
It can be assumed that safe operation is no longer possible if:
• there is visible damage to the device or to the power line,
• the device no longer works
• it has been stored for a long time under unfavourable conditions
• it was exposed to extraordinary stress caused by transport
Always observe the following safety instructions before cleaning or servicing the device:
Live components may be exposed if the covering is opened or components are removed.
Prior to start of maintenance or repair works, the device must be disconnected from all voltage
sources.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all voltage sources.
Repairs may only be carried out by qualified personnel who are familiar with the hazards
involved and the relevant regulations.
27