Displaying The Installed Codes - Renkforce 34 28 18 Bedienungsanleitung

• As soon as the TV switches off, the correct code has been found.
• Press the device key (8).
• The transmission display (2) ceases flashing.
• Your universal remote control is now programmed to control your TV.
• You can check the code by pressing the ON/OFF key (1). Press other
usable keys as well. If this doesn't work, repeat the programming
steps.
• To programme other devices, repeat the steps described for your
video recorder, your satellite receiver, your audio devices and all other
devices.
To exit the programming process during the manual search,
press one of the device keys once (8).
If you do not enter any code for a period of 30 seconds dur-
ing the manual search, the transmission display (2) stops
flashing and the device returns to its normal mode of opera-
tion.

Displaying the installed codes

You can use this function to display the installed codes with which your
devices are controlled.
This is helpful when you have forgotten a code or in order to find out a
code which was found by one of the search functions.
• Press the desired device key (8).
• Hold down the SET key (12) and press the number keys 1, 2 or 3 (13)
at the same time. Number key 1 refers to the first code number, num-
ber key 2 to the second code number and number key 3 to the third
code number.
• Release the SET key (12) and the selected number key (13).
• The transmission display (2) shows the corresponding code number
by the number of times it flashes. The transmission display (2) does
not flash for the number 0.
0 flashes = code number 0
1 flashes = code number 1
2 flashes = code number 2 etc.
• Repeat the operating steps until you have recognise all three code
numbers.
TV, VCR, SAT...
3
• Note down your code to ensure you have it for later reprogramming.
20
SET
SET
1
2
SET
Operating Instructions
English