Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Due to the precise fabrication it could be necessary to let the
turntable platter spinning some rounds turning by hand until
the remained air is removed out of the bearing.
At this stage you have completed the assembly of your CMB-
bearing.
Before listening to music, please check the set-up of the VTA
(Vertical Tracking Angle) of your cartridge.
Important Notice:
- Keep the working space clean while exchanging the CMB-
Bearing (no metal dust). You can remove any metal dust best
with a clean towel from the CMB-bearing!
- When exchanging the bearing of the Clearaudio turntable
models: "Champion Level II" as well as "Master Reference"
bring the turntable chassis into a vertical position in order to
unscrew the bearing screw. Bring the turntable chassis into
horizontal position again before removing the old bearing,
otherwise the middle bearing-housing could fall out!
clearaudio wishes you a lot of enjoyment while listening
to music!
Werbung
