Instructions For Use - MPV Medical MicroDrop Pro2 Gebrauchsanweisung

EN

Instructions for use

Before each use, the nebulizer and accessories should be cleaned according
to the instructions in the section "Cleaning, sanitization and disinfection" .
This device is intended to aerosolise drugs and solutions suitable for inha-
lation treatment to be prescribed by the doctor. If the drug or solution is too
dense, dilution with suitable saline solution might be needed, as prescribed
by the doctor.
1. Insert the power cord (Pic. D9) into a power socket corresponding to the
voltage of the device. This must be positioned so that it is not difficult to
disconnect it from the mains.
2. Open the nebulizer by turning the upper part (Pic. F1) anticlockwise.
3. Pour the drug prescribed by the physician into the lower part (Pic. F2).
Close the nebulizer by turning the upper part (Pic. F1) clockwise.
4. Connect the accessories as shown in the "Assembly diagram" . Sit com-
fortably, holding the nebulizer in your hands, place the mouthpiece over
your mouth or use the mask.
5. If you use the face mask, fit it to the face as shown in the picture.
6. Start the unit by means of switch (Pic. A2) and breathe in and out deeply
through the mouthpiece or mask.
7. When the treatment is finished, turn off the unit and disconnect the plug
from the mains socket.
8. It may happen that after a treatment session visible humidity deposits
form in the tube (Pic. C6): disconnect the tube from the nebulizer and let
it dry using the compressor air flow, as this prevents mould from gro-
wing in the tube.
A personal use of the nebulizer and its accessories is recom-
mended in order to avoid any risks of infection.
After every use, store the unit and the accessories in a dry
and dust free place.
10