VOLTCRAFT BLS-40 Bedienungsanleitung Seite 29

• Slide the on/off switch (4) to on to turn on the luggage scale. The default
unit of weight setting when you turn on the scale is >lb<. Press the
unIT/Tare button (5) to set the desired unit of weight. Repeatedly press the
unIT/Tare button to toggle between units of weight in the following order:
lb → g → kg → oz.
An acoustic signal sounds each time the button is pressed.
• Press both sides of the snap lock to open it.
• Hang your piece of baggage from the luggage strap and wait until the
weight is registered and the scale's display shows >HOLD<. An acoustic
signal also sounds. At the same time, the weight appears on the display of
your mobile device. On your mobile device, tap the field >SAVE< to save
the value.
• Proceed as follows to set the tare weight: Load the scale with the tare and
wait until the weight is registered. An acoustic signal sounds and the scale's
display shows >HOLD< when the weight is registered. Press the
unIT/Tare button. The display shows >TARE<.
• Now add the additional weight. The display of your mobile device shows the
registered weight. Tap the field >SAVE< to save the value. TARE values are
saved with a minus symbol.
• You can save up to 20 weight measurements. Each weight measurement is
stored with the respective location where the measurement was taken if you
have permitted the app to access your location on your mobile device.
In case of overload, the scale's LC display shows >Err< to indicate that
there is an error. Remove all weight from the luggage scale to prevent
damage due to overload. Observe the technical data.
29