Marmitek DORGUIAR100 Betriebsanleitung Seite 5

Step 2 Connecting the cables
• The cable included has a connector on one end. Click the doorbell camera connector
onto the connector of the cable included. Lead the cable to the place where you want to
place the monitor. (Attention: you do need a wall socket). If necessary, cut the cable to length.
• Connect the cable to the wall plate. Make sure to connect the cables as follows:
• Screw the brown wire into R1 (Video)
• Screw the black wire into R2 (Ground)
• Screw the white wire into R3 (Audio)
• Screw the red wire into R4 (Power)
• Mount the wall plate onto the wall, using the four screws included.
Step 3 Mounting the monitor
• Pick up the monitor and click the connectors of the wall plate into the
back of the monitor.
• Place the monitor against the wall plate and move it down in such a
way that it slides over the wall plate and clicks into place.
• You can always remove the monitor by sliding it up.
Your DoorGuard 100 has now been installed successfully and is ready for use.
5. Using your DoorGuard 100
• The visitor will ring the doorbell.
• The monitor will automatically switch on. You can see who's at the door and decide to
respond or not.
• To talk to the visitor, pick up the receiver.
• To open the door (only if you have also fitted an electric lock), press the Door open
button.
• Intercom function: (only if you have connected several monitors) you can communicate
to other monitors. Press the Intercom button to use this function.
6. Optional extras with your DoorGuard 100
Electric lock
Electric door lock with separate power supply.
The door-open contact is a potential-free rail switch.
Maximum load DC24V/1A or AC24V/1A.
Purchase an electric door opener from a specialist store. Connect the door opener to the L+
and L- of the wall plate.
DOORGUARD 100 5