Yard Force SDEG04B Original Bedienungsanleitung Seite 46

Fault/malfunction
Product not running.
Vibration and abnormal noise
Chips cannot meet requirement,
it is not small enough
Cause
No electrical voltage at the
device
The mains voltage is lower than
that specified
Cross section of the extension
cable no large enough and /or
the extension cable is too long.
Forward/ reverse button be set to
wrong position.
when the motor stop running,
due to overload. The reset button
is activated.
Internal wiring of machine
damaged
Motor is damaged
Switch is damaged
Fixing screws are loose
Cutting head are damaged
Blades are blunt or totally
damaged.
44
Remedy
Check the fuse , power cable ,
power plug and mains socket
and have them replaced by
qualified personnel if necessary
Contact the power supply
company if necessary
Use extension cable with larger
cross sections and/or use shorter
extension cable.
Set it to upper position.
Before restart, depress the reset
button
Contact service partner.
Contact service partner.
Contact service partner.
Tighten the relevant parts
Contact service partner
Contact service partner