Yard Force SDEG04B Original Bedienungsanleitung Seite 38

It will do the job better and safer at the rate for which it was
intended.
Secure tool
Use clamps or a vice to hold the tool, it is safer than using your
hands and it frees both hands to work on the tool.
Arrange cord
Ensure the cord is arranged so that it cannot be tripped over,
stopped on or have heavy weights rested on it and make sure
that the cord will not be subjected to any damage.
Do not abuse the cable
Never carry the tool by the cord or pull it to disconnect it from
the socket. Keep the cord away from heat, oil and sharp edges.
Do not over reach
Keep proper footing and balance at all times.
Maintaining your tool
Keep cutting blade sharp and clean for better performance.
Follow instructions for lubrication and changing accessories.
Inspect tool cable periodically and if damaged have it repaired
by an authorized service facility. Inspect extension cable
periodically and replace if damaged. Keep handles dry, clean
and free from oil and grease.
Check damaged parts
Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it
would operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving
parts, damage to parts, mounting and any other conditions that
may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized
service center unless otherwise indicated in this instruction
manual. Have defective switches replaced by an authorized
service facility. Do not use the tool if the switch does not turn it
36