Conrad P-118 Bedienungsanleitung Seite 3

G
O P E R A T I N G I N S T R U C T I O N S
Pedometer P-118 Bluetooth
Item no. 1170433
Intended Use
The device is used to measure the steps, the distances covered and the calories burned. It
features a 15-day memory.
In addition, the time (hour and minute, 12/24 hours) can be displayed.
The configuration as well as the read out and evaluation of the data takes place via the applica-
tion "iSport Activity Monitor" on your smartphone or tablet.
The data are transferred via Bluetooth
The device may only be powered by a battery (for the type, refer to the chapter "Technical
data").
Read these operating instructions completely and carefully as they contain very important infor-
mation about configuration, operation and handling. Observe all safety instructions!
Package contents
• Pedometer
• Coin cell CR2025
• Wrist strap
• Attachment clip
• Operating instructions
Safety Instructions
The warranty/guarantee will be void in the event of damage caused by failure
to observe these operating instructions. We do not assume any liability for
any resulting damage!
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions. The warranty
will be void in such cases!
Dear customer,
The following hazard information and safety instructions are intended not only to
protect your health but also to protect the device. Please read the following points
carefully:
• The unauthorised conversion and/or modification of the product is not allowed
because of safety reasons.
• If you have any doubts about the correct operation, or the safety of the product,
please consult a specialist.
• Do not expose the product to high temperatures, strong vibrations or heavy me-
chanical loads.
Do not sway the pedometer. This could damage the mechanics of the device.
• The product is not a toy and it should be kept out of the reach of children. The
product contains small parts, glass (display) and batteries. Position the product so
it is out of the reach of children.
• Handle the product with care; it can be damaged by impacts, blows, or accidental
falls, even from a low height.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
Battery Notes
• Keep batteries out of reach of children.
• Do not leave batteries lying around; there is a risk of them being swallowed by children or
domestic animals. If they are swallowed, consult a doctor immediately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable
protective gloves.
• Batteries must not be short-circuited, opened or thrown into fire. There is a risk of explosion!
• Do not recharge normal, non-rechargeable batteries, there is a risk of explosion! Only charge
rechargeable batteries that are intended for this purpose; use a suitable battery charger.
• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the battery.
www.conrad.com
4.0
®
4.0.
®
Commissioning and Settings
• Before you can use the pedometer, you have to activate the battery.
To do this, open the battery cover and take out the batteries. Now you can remove the plastic
Version 01/15
strips which are under the batteries. Afterwards, place the batteries back in the correct posi-
tion, put the battery cover on and close it.
Please also note the chapter on changing batteries in these operating instructions!
Once the button batteries have contact, all the symbols on the display light up. Once this has
happened, the product is ready to operate.
• Now install the application "iSport Activity Monitor".
For this purpose, open the respective App Store on your smartphone. For Android this is the
"Google Play Store" and if you are using an iPhone, open the "App Store".
Search for the app "iSport Activity Monitor" and install it.
If you cannot find the app in the iTunes "App Store", simply put "iSport Activity Monitor" into
the search field on your iPhone internet browser. Click on the link that guides you to iTunes
(...for iPhone, iPod Touch and iPad...). This opens the App Store on your unit and you can
install the app.
• Enable Bluetooth
menu under the section "Connections". With Apple iOS you will find the function under set-
tings in the Bluetooth
• Now start the application.
Normally the menu point "Device" opens automatically when no unit is connected. Should this
not happen, click on the app on the lower right-hand side of the wheel and then on "Device".
• After a short search, the step counter should be recognized as "MillionPedometer". If not,
then click on "Refresh".
In order to connect your smartphone with the pedometer, click on the text "MillionPedometer,"
which has a grey background. Once your smartphone is connected to the step counter the
text will turn blue and the word "(Paired)" is displayed.
Please note that the unit is not displayed as a connection in the Bluetooth
smartphone.
• Then change to the settings by tapping on the gear wheel in the App.
• Here, enter the following data or select the following. The desired unit of measurement, your
date of birth, you weight, your gender, your target steps and your stride length. To save the
settings tap on "SAVE".
Keep in mind that the information can only be synchronised to the pedometer if it is not in
sleep mode.
Function and operation
• The display and its functions:
1 Clock with hour and minute display; 12/24-hour format
2 The steps taken so far
3 The calories burned so far
4 The distance covered so far
The display switches to the next indication every 5 seconds. In this process, the se-
quence corresponds to above illustration. If you wish to switch to the next indication
manually, you just have to slightly tap on the pedometer.
1 The icon indicates that the clock functions in 12-hour format. In the 24-hour format this
indication is off. Your smartphone will save the hour format.
2 The bar-graph graphically displays the target of steps you have set. Each bar corresponds
to 10% of the set steps.
3 If you have configured a target, this symbol will be shown. If your target is reached, the
symbol starts to flash.
4 The battery symbol lights up when the battery has only a remaining capacity of 20%. In that
case, we recommend to replace the coin cell immediately.
5 The Bluetooth
on your smartphone. With Android you will find the function in the settings
®
section.
®
symbol lights up when the synchronisation takes place.
®
settings of your
®