Remington HC4250 Handbuch Seite 7

ENGLISH
C CARE FOR YOUR HAIRCLIPPER
• To ensure long lasting performance of your clipper, clean the blades and
unit regularly.
• Always keep the clipper in the provided travel pouch.
• Ensure the appliance is switched off and unplugged from the mains before
cleaning.
• Do not use harsh or corrosive cleaners on the unit or blades.
• Cleaning should be done with a soft brush.
• After each use - brush the accumulated hair from the blades.
, WASHABLE CLEANING
• The QuickCut Clipper is fully washable for easy cleaning.
• Ensure the appliance is switched off and unplugged from the mains.
, WASHOUT PORT INSTRUCTIONS
, Note: Never rinse, wash or otherwise subject this product to liquid whilst the
power cord is connected.
• For best results, keep trimmer running while running it under the tap. Allow
water to run through the washout port and over the blades. Recommended
to rinse after each use.
• Ensure the clipper is dry after cleaning.
• For more thorough cleaning the blade set can be easily removed to wash
any hair trimmings from the blades. To release the blade set, push the blade
set release button found on the base of the clipper.
• Ensure the blades are dry after rinsing under the tap. To reattach, align the
blade set onto the clipper and push the blade set towards the clipper body
until it clicks into place.
• Place a small drop of cutter or sewing machine oil onto the blades at each
end and at the middle point of the blades. Turn the unit on for a few
seconds to distribute the oil then turn off and wipe off excess oil.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
• Ensure the clipper is discharged of all power.
7