Setting Pads, Programming The Drum Kit; A) Selecting The Drum Sound For A Pad; B) Setting The Volume For A Pad - MC Crypt 30 39 97 Bedienungsanleitung

12. Setting Pads, Programming the Drum Kit

After the device is switched on, drum kit "001" is automatically activated. The first 25 drum kits "001" to "025" contain specific pre-settings by the
manufacturer, see Appendix B (Chapter 21).
You can save your own combinations of allocated sounds for the 7 pads and 2 foot pedals in the drum kits "026" to "030"
The following settings can be made:
• Drum sound
• Pad volume
• Stereo effect
• Pad sensitivity (for the 7 pads only, not the foot pedals)
If another drum kit is selected (see Chapter 11. b) then all the previous settings you have made will be lost!
If you would like to save a specific setting, then please refer to Chapter 12. e).

a) Selecting the drum sound for a pad

If you are not satisfied with the 30 pre-installed drum kits (see Chapter
10. a) you can of course reconfigure the pads.
The settings in the following sections from c) to f) can be saved
later in one of the drum kits from 026 to 030.
Activate the settings menu by pressing the "PAD ASSIGN" button (11)
once. The decimal point in the display glows next to "PAD"
Hit the pad which you wish to change the sound of. The current sound
is played via the speakers or the headphones.
If the same pad is struck again, the next sound will be played.
Of course you can also use the "SELECT +" and "SELECT -" buttons
(15) or the adjustment wheel (20) to select a sound.
In Appendix A (Chapter 20) you will find a table with all the sounds.

b) Setting the volume for a pad

The volume of each pad can be independently adjusted.
Press the "VOLUME" button (14) once.
Hit the pad which you wish to adjust the volume of.
Then you can use the "SELECT +" and "SELECT -" buttons (15) or the
adjustment wheel (20) to alter the volume.
33