Renkforce 1007805 Bedienungsanleitung Seite 4

d) Countdown timer
Setting the time target
• Press the RST/STP(1) key, until the hour display flashes.
• Set the hour target with the ST/LAP + (3) and EL - (4) keys.
• Press the MODE key (2) to switch to the next setting step (minutes).
• Set the minute target with the ST/LAP + (3) and EL - (4) keys.
• Press the MODE key (2) to switch to the next setting step (seconds).
• Set the second target with the ST/LAP + (3) and EL - (4) keys.
• Press the RESET key (1) to save the time target.
Use of the countdown timer
• Press the ST/LAP (3) key to start the countdown timer.
• Press the RST/STP (1) key to pause the countdown timer.
• With the ST/LAP (3) key, the countdown timer can be restarted.
• When the preset time has passed, an acoustic signal is emitted for approx. 60 seconds.
• Press any key to turn the acoustic signal off.
e) Alarm function
Activating or deactivating the alarm function
• Press the RST/STP (1) key to select the desired function (hour signal or alarm 1-5).
• To activate or deactivate the hour signal or the selected alarm, press the ST/LAP (3) key.
With activated hour signal, a bell icon appears on the right bottom of the display. With activated
alarm, an alarm symbol appears.
• At the set alarm time an alarm sound is emitted for approx. 60 seconds. Press any key to turn the
alarm sound off.
Alarm time setting
• Select the alarm function to be set (alarm 1-5) using the RST/STP (1) key.
• Hold the RST/STP(1) key, until the hour display flashes.
• Set the hours with the ST/LAP + (3) and EL - (4) keys.
• Press the MODE key (2), until the minute display flashes.
• Set the minutes with the ST/LAP + (3) and EL - (4) keys.
• Press the RST/STP key (1) to save the setting.
e) Time of the second time zone
• Hold the RST/STP(1) key until the hour display flashes.
• Set the hours with the ST/LAP + (3) and EL - (4) keys.
• Press the MODE key (2), until the minute display flashes.
• Set the minutes with the ST/LAP + (3) and EL - (4) keys. The minute display is changed in
30-minute steps.
• Press the RST/STP key (1) to save the setting.
Illumination
• Press the EL key (4) to turn on the clock face light for a few seconds.
Battery Notes
• Batteries should be kept out of the reach of children.
• Do not leave batteries lying around in the open; there is a risk of them being swallowed by
children or pets. If they are swallowed, consult a doctor immediately.
• Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable
protective gloves.
• Batteries must not be short-circuited, opened or thrown into a fire. There is a risk of explosion!
• Do not recharge normal, non-rechargeable batteries, due to risk of explosion! Only charge re-
chargeable batteries that are intended for this purpose; use a suitable battery charger.
• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the battery.
Changing the Batteries
• If the display does not show anything, the battery has to be replaced.
• Replacing the battery should be done by a specialist, using special clockmaker tools and profes-
sional knowledge.
• To replace the battery, the bottom of the casing is removed.
• The battery can then be removed from its holder and be replaced.
Water and Shock Resistance
In normal use, the wristwatch is protected against shocks. Nevertheless, do not expose the device
to extreme shocks such as it might occur if the device falls onto a hard surface. This might damage
the watch mechanism.
The labelling 10 ATM means that the watch is suitable for bathing, swimming, car wash, showering
and so on.
It is not a diver's watch. Never press the buttons under water.
Maintenance and cleaning
To clean the outside of the watch, a dry, soft, clean cloth is sufficient. For heavier soiling of the
exterior, you can moisten the cloth slightly with lukewarm water.
Clean the watch very carefully; otherwise you may scratch it.
Do not press too heavily on the glass cover, as this can lead to breakage
Disposal
a) Product
Electronic devices are recyclable waste materials and must not be disposed of in the
household waste!
Dispose of an unserviceable product in accordance with the relevant statutory regulations.
Remove the battery if there is one inserted and dispose of it separately from the product.
b) Normal and Rechargeable Batteries
As the end user, you are required by law (Battery Regulation) to return used batteries and re-
chargeable batteries. Do not dispose of used batteries in the household waste!
Batteries/rechargeable batteries contain harmful materials and are labelled with the
symbol shown to indicate that disposal in the household waste is forbidden. The sym-
bols of the relevant heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (marking
can be seen on the battery/rechargeable battery, e.g. underneath the refuse bin symbol
shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the official collection
points of your community, in our stores, or at places where batteries or rechargeable batteries
are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the environment!
Technical data
Operating voltage.........................................3 V/DC
Battery 1 x lithium coin cell ........................CR2025
Battery life ...................................................approx. 2 years
Water-tightness ............................................10 ATM
Weight ............................................................58 g
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2014 by Conrad Electronic SE.