Hettich LegaDrive Bedienungsanleitung Seite 4

GB
Press the arrow key for retracting the lifting column.
Hold the key until the lifting column was retracted
or
completely and the stopped in the base position.
The piece of furniture can now be adjusted.
4
Top and bottom stop position
These two features can be used to limit the travel range of the LegaMove /
LegaDrive lifting column system (and/or of the piece of furniture), e.g. when
an obstacle is located within the travel area.
A bottom stop position can be set within the lower half of the travel; a top
stop position within the top half of the travel. Once a bottom stop position
has been set, it is used as the new bottom position; the top stop position
corresponds to the new top position of travel. Carry out the following steps
to save a bottom / top stop position:
Note
These steps must be carried out separately for a bottom
stop position as well as for a top stop position!
Set the LegaMove / LegaDrive lifting column system to the
1. 1.
position that is to be defined as the bottom / top stop
position.
or
To do so, press the lifting column system down key or the
lifting column system up key until the desired position is
reached.
Simultaneously press the lifting column system up key and
the lifting column system down key and hold both keys
2. 2.
and
down for approx. 10 seconds.
The control unit issues a double click when the position is
saved.
5
To disable a bottom / top stop position
Carry out the following steps to disable a bottom / top stop position:
Note
These steps must be carried out separately for a bottom
stop position as well as for a top stop position!
Move the LegaMove / LegaDrive lifting column system to any
1.
position within the lower half of the travel range to disable a
bottom stop position, or to any position within the upper half
or
of the travel range to disable the top stop position.
To do so, press the lifting column system down key or the
lifting column system up key until the desired position is
reached.
Simultaneously press the lifting column system up key and
the lifting column system down key and hold both keys
2.
and
down for approx. 10 seconds.
The control unit issues a single click when the position is
disabled.
4
6
Manual reset
A manuel reset is required after replacing of components (e.g. lifting
column).
Note
The manuel reset may only be carried out when the
piece of furniture is unladen. Ensure that the LegaMove
/ LegaDrive lifting column is capable of being retracted
completely as otherwise an incorrect reset position will
be saved. This can result in damage to components and
collisions during subsequent operation.
Attention!
The collision detection (ISP) is not active
during all reset procedures and during the end-
of-travel adjustment. Pay attention to a possible
risk of squashing!
Press the arrow key for retracting the lifting column.
1.
Hold the key until the LegaMove / LegaDrive lifting column is
or
retracted completely and stopped (programmed end position).
Press the relevant arrow key again and keep it pressed.
After approx. 5 seconds, the lifting column is retracted further
2.
or
until it reaches the absolute bottom position.
Release the relevant arrow key. The electrically height-
adjustable piece of furniture can now be used again in the
3.
or
normal way.
7
Replacing the batterie
Button cell CR 2032 / 3V
Note
Immediate remove used button cells (batteries) and
dispose of them in an environmentally friendly manner.
They must not be discarded with household rubbish!
Replace button cell with identical type only.
1.
www.hettich.com
3.
2.