Setting The Clock; Weighing Mode; Temperature Mode; Disposal - Conrad ES-01 Bedienungsanleitung

Setting the clock

After fitting new batteries, the clock needs to be reset. This is what
you do: press the button Mode/Temp. The minute display flashes.
You can now set the minute display to the correct time by pressing
the button Set/Zero. Repress the button Mode/Temp. The hour dis-
play flashes. You can now set the hour display to the correct time
by pressing the button Set/Zero. The symbols AM (hours 1 to 12) or
PM (hours 13 to 24) are displayed left of the clock time. Keep pres-
sing the button Set/Zero until the correct clock time has been set.
Then repress the button Mode/Temp. Only the two dot separator
between minute and hour display can be seen (flashing).

Weighing mode

Press the button Clock/Scale once. This causes a reset, and all
segments are displayed.
Shortly, the display will show „0.00 kg". If not, reset the display to
zero by pressing the button Set/Zero once. Install the object to be
weighed on the hook. An arrow pointing left is displayed and there
is a beep approximately every three seconds, when the display is in
steady-state. The weight display continues to show for seven se-
conds even after the weighed object is removed from the hook.

Temperature mode

For the best results when measuring temperature, protect the devi-
ce from direct exposure to the sun and do not hold it directly (body
heat). According to the change in temperature, it may take some
moments before a relatively accurate reading is displayed. The mo-
re frequent or intensive a temperature change, the longer it will take
to achieve a stable temperature display.
To measure temperature, press the button Clock/Scale once, and
then the button Mode/Temp. The temperature (in C) is then displayed.
8

Disposal

If your Electronic Balance has become unusable (irreparable, no
display even with new batteries) please dispose of it according to
current legal regulations.

What to do in case of malfunction

In purchasing the Electronic Balance ES - 01 you have acquired a
state-of-the-art product which is operationally safe. Even so, mal-
functions may occur. This section tells you how to deal easily with
some of these possible malfunctions:
Problem Possible solution
No display The batteries are worn out
The batteries are not fitted correctly
(polarity)
Display shows „F.FF" This is shown when => weight is greater
than 8 kg
Temperature too high The balance was stored directly
exposed to sunlight
The balance was held directly for too
long a period
Important!
Please make absolutely sure to observe the Notes
in Safety!
9