Error Indication - Rotel 1119Ch Gebrauchsanweisung

 ERROR INDICATION
o The following points are the most common problems encountered when using the
product, along with the possible causes and suggested solutions.
o It is strictly intended as a user's reference only.
o If the following solutions do not work for the product, please send to be repaired.
Problem
No Power
Machine stops operating
Error indication: E1
Machine stops operating
Error indication: E2
Machine stops operating
Error indication: E3
Machine stops operating
Error indication: E4
Machine stops operating
Error indication: E5
Machine stops operating
Error indication: E6
Cannot control the power or temperature
level during operation
Water is not boiling during operation
Machine is heating and stops under Low
power
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
Possible Cause and Solution
Is there a power shortage in your area?
Is there a short circuit in the power source
of your home?
Is the power plug too loose or not
connected well?
Is the cookware not suitable for an
induction cooker?
Is the cookware positioned properly?
Is the cookware empty or cooking
temperature too high?
Is the air inlet and/or outlet blocked?
Is the surrounding temperature too high?
Turn off the machine and restart after 5
minutes. If E2 still persists, please send to
be repaired.
Is the main power supply over AC 275V?
Is the main power supply lower than AC
100V?
Is the temperature sensor of the machine
not working?
Please send to be repaired.
Is the cookware positioned properly?
Is the cookware empty?
Is the bottom of the cookware not flat?
Use flat bottom cookware for better heat
transferal.
Is the water capacity less than 1L or more
than 4L?
Is the cookware not suitable for induction
cooker?
Is the room temperature below 5 C?
For example, if you set the power as 80W,
the machine will produce 80W heat and
stop operating, and once the heat is below