Connection; Signal Input Connection - Renkforce M.A.R.L.I.S. Bedienungsanleitung

9. Connection

a) Signal Input Connection
The PA speaker set is equipped with symmetrical XLR plug combination sockets and additionally with asymmetric
cinch connections. The connections selected do not affect function. Only use one connection type at a time, though.
When connecting the signal inputs, make sure that the connection cables are neither pinched nor damaged
by sharp edges.
The inputs must only be connected to low-level audio device outputs of audio devices.
The PA speaker set and the device it is connected to must both be switched off during connection.
For the connection of the RCA inputs, only use suitable shielded cinch or XLR or jack-plug lines. Use of any
wrong cables may cause interferences.
To avoid distortion or mismatching that may damage the PA speaker set, only audio devices with a cinch
output may be connected to the cinch inputs of the device. Only devices with XLR or jack outputs must be
connected to the XLR-jack combination inputs.
Connecting the LINE Inputs
• Connect the connections INPUT (cinch) (11) or the connections INPUT (XLR/jack plug) (12) to the pre-amplifier
outputs of the upstream audio device (e.g. mixer).
• Connect the RIGHT connection to the right pre-amplifier output and the LEFT connection to the left pre-amplifier
output.
27